MO 3.3, MO 3.4, MO 3.5
5
1.5.3 Power supply and operating mode
Supply voltage:
Electric-motor .........
Υ
/
Δ
; 400 / 230V AC respectively
Υ
/
Δ
; 380 / 220V AC
±
10% (other - after agreement
with manufacturer)
Control .................................................................................................................................... 230 V AC
±
10%
Supply voltage frequency ........................................................................................................ 50/60
*
Hz
±
2%
·
For 60Hz frequency is control speed increased by 1, 2 multiple.
Operating regime
(according to
Č
SN/STN IEC 60034-1, 8)
:
·
EA MO 3.3, MO 3.4 resp. MO 3.5
are designed for
remote control
:
·
with short-time run S2-10 min.
·
with interrupted run S4-25%
, 6 up to 90 cycles / hr.
·
EA MO 3.3, MO 3.4 resp. MO 3.5 with controllers are designed for automotive regulation:
·
with interrupted run S4-25
%, 90 up to 1200 cycles per hour
1.6 Packaging, transportation, storage and unpacking
EA MO 3.3, MO 3.4 resp. MO 3.5
are supplied in packages, warranting resistance according to
requirements of standards STN EN 60 654.
Package is a box. Products in boxes is possible to load on the pallets (pallet is returnable). On the outer
side of the package is stated:
·
manufacturer label,
·
name and type of product,
·
number of pieces,
·
other data – notices and stickers.
The forwarder is obliged to secure packed products, loaded on transportation means, against self-
motion; if open transportation means are used, to secure their protection against atmospheric precipitations
and splashing water. Displacement and securing of products in transportation means must provide their
stable position, exclude the possibility of their inter-collision and their collision with the vehicle walls.
Transportation can be executed by heatless and non hermetic spaces of transportation vehicles with
influences within the range:
- temperature: -25° C up to +70° C (a strange version –45 ° C up to +45 ° C
- humidity: 5 up to 100 %, with max. water content 0.028 kg/kg of dry air
- barometric pressure 86 up to 108 kPa
Upon receiving of EA examine, if during transportation, resp. storing did not come to its
damage. At the same time verify, if the data on the labels corresponds to accompanying
documentation and purchase-sale contract / order. Eventual discrepancies, faults and damages
should be reported without any delay to supplier.
Electric actuators and their accessories must be stored in dry, well ventilated covered spaces,
protected against impurities, dust, soil humidity (by placement to racks, or on pa-lettes), chemicals and
foreign interventions, at ambient temperature from -10°C up to +50
°
C and at relative air humidity max. 80
%.
Attention!
1. It is not acceptable to store EA outdoors, or in areas not protected against direct climate
influence!
2. It is not recommended to set up the electric actuator manually without mechanic con-nection with
armature. The electric actuator does not have mechanic restriction of wor-king stroke in terminal
positions and therefore can after exceeding of the stroke come to mistuning of parameters set up
by production plant.
3. Eventual damages to surface finish remove without delay – thus preventing damage by corrosion.
4. If storing takes longer than 1 year, it is necessary to inspect lubrication fillings before putting EA
into operation.
5. Assembled EA, but not put into operation is necessary to protect by the equivalent method as
during storage (for example suitable protective cover).