Wiring to Motion Light &
Standard Fixture
(Standard)
Two Motion Lights
RED to
BLACK
BLACK
BLACK
WHITE
WHITE
BLACK
OPTIONAL WIRING:
One Motion Light
BLACK
WHITE
1. Connect Bare wire
to ground screw
3. Black to black
2. White to white
Ground
Screw
Notch
Junction
Box
Screws
Fixture
Screw
Fixture
Screw
Remove ground screw and 2 fixture screws
from the mounting plate. Flip plate over and
rotate 90
°
. Re-insert ground screw. Insert the
2 fixture screws in the holes near the junction
box screws holes. Route wires through notch
in adaptor plate.
When wiring to additional standard
fixture only: Strip the motion sensor's
red wire and connect to the standard
light's black wire. Connect all white wires
together. Total fixture ratings must not
exceed 400W (3.3 A.).
❒
Turn power off at circuit breaker.
INSTALLATION
Junction
Box
Horizontal Junction Boxes Only:
1. Remove
two nuts.
2. Remove
Mounting Plate.
4. Screw in mounting
plate to junction box.
MAX
SENS
MIN
3. Set sensitivity range
on fixture back.
❒
Caulk fixture and mounting surface
with silicone weather sealant.
❒
Install three 60W bulbs in candelabra
style lights.
Slide the fixture onto
the mounting screws
and tighten nuts.
