12
10. Basic functions of the transmitter
a) Selecting colour of LEDs or turning LEDs off
The colour for the LEDs (16) of the battery/rechargeable battery status indicator is adjustable, and these can also be
turned off.
Proceed as follows:
•
Switch on the remote control.
•
Press and hold down the "BACK" button (13) and turn the knob (14) to the left or right until the desired colour (you
can select green, blue, cyan, red, yellow and white) is set for the LEDs or until they are disabled.
•
Now release the "BACK" button (13).
If you have deactivated the LEDs, the transmitter can no longer indicate by the flashing LEDs that the
voltage is too low!
b) Calibrating the steering wheel and the throttle/brake lever
This calibration stores the end positions of the steering wheel (4) for channel 1 and the throttle/brake lever (6) for
channel 2 anew.
If you do not bring the steering wheel and the throttle/brake lever to the respective end position (end stop)
during calibration, the full control travel will not be available later. Additionally, this might make the vehicle
uncontrollable.
Proceed as follows for calibration:
•
Switch off the remote control.
• Turn the steering wheel clockwise all the way to the right (as far as it will go); see figure on the right.
Hold the steering wheel in this position and turn on the transmitter.
•
The "STK.CAL." indication will appear at the bottom of the display.
•
Release the steering wheel so that it is in the middle position.
• If you press the knob (14) briefly, the "STK.CAL." indication will start flashing.
•
Now move the steering wheel (4) and the throttle/brake lever (6) to the respective end positions (end stop).
To do this, turn the steering wheel all the way to the right and then to the left until it stops. Release the steering
wheel. Then pull the throttle/brake lever by the handle until it stops and push it away from the handle as far as it will
go. Release the throttle/brake lever.
The order is irrelevant, only the respective end positions are saved.
