Reely 1277994, Operating Instructions Manual

Page: 42 / 108

42
b) Connecting the Drive Battery
Switch on the transmitter and set the trimming of all control functions to the neutral position. Observe the information
and instructions in the operating instructions of the remote control system.
Place the boat on a suitable surface (e.g. on the included boat rack) so that the ship‘s propeller can move freely.
Connect the plug connections on the driving battery to the counter-piece of the speed controller (also see figure 5,
item 3).
The speed controller starts to initialise at once. When everything is just right, this is indicated with a brief signal sound.
The speed controller is now ready for operation. In this case, undervoltage recognition is not programmed. Also ob-
serve the notes in chapter „Programming the speed controller“.
If several signal sounds (e.g. 3x beeps) are reported acoustically, the speed controller is ready for operation as well. In
this case, however, it is signalled that the speed controller is programmed for operation with a 3-cell LiPo battery and
an undervoltage recognition. Also observe the notes in chapter „Programming the speed controller“.
If successful initialisation is not reported acoustically, the speed controller is not ready for operation either.
In this case, carefully adjust the speed control trimming at the transmitter (see operating instructions of the
remote control system) until the sound signals are issued.
You may also need to remove the drive battery for this. It must be reconnected after approx. 10 seconds.
When this measure does not lead to success, the neutral position for the drive function must be program -
med. Also observe the notes in chapter „Programming the speed controller“.