Reely Sky 23 04 49, Operating Instruction

Page: 16 / 36

16
6. Charging procedure
Before you charge your aeroplane model, switch off the on/off switch on the bottom of the fuselage. Check the correct assembly of the model once
more. If everything is fine, you can now charge the aeroplane model.
Insert the plug of the charging unit in the charging socket. The charging socket is also at the borrom of the fuselage. Ensure that the plug fits into
the socket in one direction only.
Then insert the charging unit into your car’s cigarette lighting socket (12-Volt voltage, with minus in masse). Turn the charging unit’s switch to a
maximum of Drehen 8 to 10 minutes. If the charging procedure has finished (duration approx. 8 to 10 minutes), the charging unit will automatically
switch off. Please do not set a longer charging time, as this will damage the aeroplane battery.
First discnnect the plug from the cigarette lighting socket and then the charging plug from the charging socket.
7. Trimmen
Bevor der erste Flug durchgeführt wird, ist es unbedingt notwendig, dass Ihr Flugmodell korrekt justiertbzw. abgeglichen (= getrimmt) wird!
Always ensure that no people, animals or objects are put at risk through the operation of the model aeroplane. (risk of injury or damage)
Special care is also required near trees, high-voltage lines, etc. Never operate the engine in closed rooms.
In this conext obsever sections „Intended use“ and
„Safety instructions“.
1. Select an open field or meadow.
2. Charge your model aeroplane.
3. Pull the aerial of the remote control our completely and flick the switch of the remote control into the „ON“ position. (left control stick steers the
engine, right control stick steers the vertical rudder). Then switch on the model aeroplane. (slide switch in the „ON“ position) To this end, observe
the „Commissioning“ section.
4. Push the slide switch into the „ON“ position.
5. Now release your model aeroplane with a slight push into the wind.
6. Please observe the flight directoin and the following figure. No trimming is required for flight direction „C“. In this case you can skip to section
„Commissioning“ directly.
If your model aeroplane flies in one of the flight directions „A, B, D and E“, please observe that the settings regarding height rudder and
vertical rudder are only minor and that this requries several attempts until your model complies with the „C“ flight direction. You can also
fix the settings with the supplied glue, if applicable.