53
• Only now must the throttle/brake lever be released (neutral position).
Then the LED flashes and the motor emits brief sound signals (beep-beep-pause-beep-beep). The speed controller
is now in programming mode.
If this is not the case, you released the throttle/brake lever prematurely and the programming mode has not
been started.
Proceed as described again.
The overall duration of how long you have to keep the throttle/brake lever in the full throttle position for
forward driving after the speed controller has been activated is about 15 seconds. Only then will the pro-
gramming mode be active.
• The speed controller then shows the function in which it is or which setting value is currently active by the number
of LED flashes and sound signals emitted through the motor.
Right after calling the programing mode, the motor repeats the sound signals „beep-pause-beep“ and the LED
flashes yellow briefly. This means that the function number is „1“ and the setting value is „1“.
The throttle/brake lever of the transmitter then can be used for programing of the speed controller.
1) Put the throttle/brake lever at the transmitter into the forward driving position for the duration of
3 seconds (pull lever to the handle)
This means „yes“. The LED flashes green and the motor issues sound signals. Then release the throttle/
break lever again (neutral position) to call the next function and display the function number and the first
setting value by LED flashes and motor sound signal.
2) Put the throttle/brake lever at the transmitter into the reverse driving position for the duration of 3
seconds (push lever away from the handle)
This means „no“. The LED flashes red and the motor issues sound signals. Then release the throttle/break
lever again (neutral position) to display the next setting by LED flashes and motor sound signal.
To get to the next function, either confirm a setting with „Yes“ (see above) or confirm all available settings
with „No“.
If all available settings are confirmed with „no“, the present programing of the respective function is not
touched. Only if you confirm the setting with „Yes“ will the programming of the corresponding function of the
speed controller be changed and saved!
The function number and the setting are separated by a brief pause. The motor repeats, for example, the following
sound sequence:
Beep - beep - short pause - beep - long pause.........
This means that the speed controller is in function 2 (= brake force at forward driving) and the setting is 1 (= 25%).
• Not all 9 functions need to be gone through in sequence. A premature end of programing is possible by deactivating
the speed controller. All changes performed before that (that have been confirmed with „Yes“, see above) are assu
-
med.
Summary of Contents for 40 95 98
Page 130: ...130 ...
Page 131: ...131 ...
