15
22. Press the
RUN/PAUSE
button again to resume testing.
23. When the end time is reached, both the DUR and LOGGER icons
will stop flashing and the final accumulated noise exposure value is
displayed.
24. To end the current session, first unlock the keypad again and press
and hold the
ENTER
button for 2 seconds.
25. Press the
FUNC.
button to resume normal operation.
%DOSE Testing Notes:
• Never shout into the microphone as this will affect the test results.
• Microphone should not come into contact with any objects during
recording to avoid erroneous test results.
• For best results, test over the course of several days and average
the %DOSE.
Data Logging
Sound Pressure Level (SPL) Data Recording Modes
Manual Data Logging:
Manually log readings into the internal memory
(see
Manual Data Logging Mode
section for details).
Automatic Data Logging:
Setup the meter parameters in order to
automatically log data into the internal memory.
Note:
The meter can store up to 16,000 data points and will indicate
"FULL" on the LCD display when this amount is exceeded.
Please note to use the data logging feature for Sound Level Pressure (SPL) the optional
PC software (R8085-PC) and USB cable (R8085-USB) are required. With the software,
all stored readings that are captured can be downloaded and exported to Excel for
further analysis.
SPL Manual Data Logging Mode
In manual mode the
LOG
button is pressed to manually log a reading into
the internal memory at any time. In order to setup the meter for manual
data logging, follow steps 1 through 4 below.
1. Set the data logging sampling rate to "0" seconds.
2. Press and hold the
LOG
button to enter manual data logging mode.
3. Press the
LOG
button to save a reading to memory. "LOGGER" will
flash each time a data point is stored.
continued...
www.
GlobalTestSupply
.com
Find Quality Products Online at:
