8
3. Press the
SV
button a third time to stop the timed measurement and
the accumulated value will appear on the LCD display.
4. Press the
SV
button again to return to infinite dose mode.
Note:
At any time, you can press the
ESC
or UNIT buttons to exit the
dose accumulation mode and resume normal operation.
Setting Dose Accumulation Time
1. While in dose accumulation time mode press and hold the
SV
button for 2 seconds.
2. The icons "μSv" and "min" will appear on the LCD display along with
060 (default set time) which indicates 60 minutes of set time.
Note:
The maximum set time value that can be set is 999 minutes.
3. Make sure to start with the leftmost digit.
4. To toggle between digits press the
button to move to the next
digit or press the
ESC
button to return to the previous digit.
5. When ready, press the and arrows to adjust the flashing digit.
6. Press the
button to confirm your selection and proceed to the
next digit.
7. When the last digit has been selected and confirmed, the set time
will no longer be flashing.
Note:
The selected set time is automatically configured for pulse
counting time.
8. Press the
button to begin measuring the dose accumulation for
the set amount of time.
9. Throughout the measurement process, the "TIME" icon will blink on
the LCD display.
10. The meter will beep when the set time is up and the accumulated
dose value will appear on the screen.
11. At any time, you can press the
SV
button to pause the timer, and
press it again to resume the measurement process. Press and hold
the
SV
button to re-enter the timing setup mode if required.
Note:
The instrument will exit the timed dose setup after approximately
15 seconds of inactivity.
continued...
REED Instruments
1-877-849-2127 | [email protected] | www.reedinstruments.com
