16
Manual Data Logging Mode
In manual mode, the
LOG
button is pressed to manually log a reading on
the inserted SD card at any time. In order to setup the meter for manual
data logging, follow steps 1 through 8 below.
1. Set the data logging sampling rate to "0" seconds (see
Setting the
Data Logging Sampling Rate
section for details).
2. Press the
REC
button and "REC" will appear on the LCD.
3. The meter will also display P-X (X = memory position number
between 1 and 99).
4. Press the
SET
button to enter the data memory positions selection.
5. Press the and buttons to select one of the 99 data memory
positions in which to record.
6. Press the
ENTER
button to confirm selection.
7. Press the
LOG
button again to save a reading to memory. "REC" will
flash each time a data point is stored.
8. To exit manual data logging mode, press and hold the
REC
button
2 seconds to resume normal operation.
Automatic Data Logging Mode
In automatic mode the desired data logging sampling rate is set to 1, 2,
5, 10, 30, 60, 120, 300, 600, 1800 or 3600 seconds prior to recording (see
Setting the Data Logging Sampling Rate
section for details). in order to
setup the meter for automatic data logging, follow steps 1 through 5 below.
1. To begin a data logging session Press the
REC
button and "REC"
will appear on the LCD.
2. Press the
LOG
button. The meter will scan for a SD memory card.
If a card is not inserted or the card is defective, the meter will flash
"CArD -E-" indefinitely. in this case, power the meter OFF and try
again with another SD memory card.
3. The "REC" icon will appear on the LCD and will continuously flash
while in a data logging session.
4. To pause the data logging session press the
LOG
button and "REC"
will stop flashing. To resume press the
LOG
button again.
5. To end the current data logging session pause the data logging
session and hold the
REC
button until "REC" disappears.
continued...
REED Instruments
1-877-849-2127 | [email protected] | www.reedinstruments.com
