13
Setting the Time and Date (dAtE)
1. Press the
ENTER
button when "dAtE" appears on the LCD.
2. Press the and buttons to adjust the year as indicated by "YY".
3. Press the
ENTER
button to confirm selection.
4. Repeat steps 2 and 3 for month, day, hour, minute and seconds as
indicated by (mm/dd/h/m/s).
5. After each value has been selected and confirmed, the meter will
automatically skip to the next parameter.
Note
: At any time, you can press the
ESC
button to exit the Setup mode
and resume normal operation. The internal clock will keep accurate time
when the meter is powered off. When new batteries are installed the clock
will have to be reset.
Setting Data Decimal Format (dEC)
Numeric formats vary in different countries. By default the meter is set to
bASiC mode where a decimal point is used to separate units, (i.e. 20.00).
The European format uses a comma (i.e. 20,00) to separate units. To change
this setting, follow steps 1 and 2 when "dEC" appears on the LCD.
1. Press the and buttons to select between bASIC and Euro.
2. Press the
ENTER
button to confirm selection and skip to
next parameter.
Note:
At any time, you can press the
ESC
button to exit the Setup mode
and resume normal operation
Enabling/Disabling Auto Power Off (PoFF)
Follow steps 1 and 2 when "PoFF" appears on the LCD.
1.
Press the and buttons to select between On (enabled) or OFF
(disabled). With the Auto Power OFF feature enabled, the meter will
automatically switch OFF after 10 minutes of inactivity to preserve
battery life.
2. Press the
ENTER
button to confirm selection and skip to
next parameter.
Note
: At any time, you can press the
ESC
button to exit the Setup mode
and resume normal operation.
continued...
REED Instruments
1-877-849-2127 | [email protected] | www.reedinstruments.com
