9
6
6. Identify the Right Link Arm (10), which is marked
with a “Right” sticker, and orient it as shown.
Insert the Right Link Arm (10) into the Right
Pedal Arm (8) and slide it onto the Right Upper
Body Leg (12).
Locate the M12 x 97mm Shoulder Patch Screw
(71) in the Right Link Arm (10). Tighten the
Shoulder Patch Screw into the indicated post on
the Right Pedal Arm (8)
halfway.
Next, locate the M12 x 97mm Shoulder Patch
Screw (71) in the Right Upper Body Leg (12).
Tighten the Shoulder Patch Screw into the post
on the Right Link Arm (10).
Finish tightening the M12 x 97mm Shoulder
Patch Screw (71) into the Right Pedal Arm (8).
Repeat this step to attach the Left Link Arm
(not shown).
12
71
71
Post
10
8
7.
See the upper drawing.
Identify the Right
Upper Body Arm (31), which is marked with a
“Right” sticker, and orient it as shown.
Have another person hold the Right Upper Body
Arm (31) near the Right Upper Body Leg (12)
while you perform the following actions:
Slide an Arm Cover (30) upward onto the Right
Upper Body Arm (31).
Locate the wire tie in the Right Upper Body Leg
(12). Tie the end of the wire tie to the right Grip
Wire (132). Carefully pull the other end of the
wire tie upward out of the Right Upper Body Leg.
Then, untie and discard the wire tie.
Tip: It may
be helpful to push the Grip Wire while pulling
the wire tie.
See the lower drawing.
Insert the right Grip
Wire (132) into the right side of the Upright (6)
and pull it upward out of the top of the Upright.
Repeat this step on the other side of the
elliptical.
7
31
30
12
132
132
132
Wire Tie
Pull
31
12
6
