•
Locate the laser etched motor mount standoff drill
points. Use a smaller bit and increase size as you get to
the correct diameter for the screws in your standoffs
•
Install the Standoff's with provided bolts. Install the
bolt into a flat washer then insert into the firewall, then
drop Blue Loctite on the threads and tighten standoff.
Repeat until all four are installed.
•
Temporarily mount the motor on the standoff's, mark the location of the fuel line and
carburetor throttle arm. Remove motor and drill to appropriate size for fuel line and your
throttle push rod.
◦
Attach a ball link to the throttle push rod and secure to the carburetor throttle arm
with a bold and nylon locking nut
•
Locate the pre glued throttle servo mount bracket and
find an ideal location inline with the throttle push rod
installed earlier.
