•
locate the re installed Pull Pull wire at the rear of the
fuselage. Remove tape and thread the brass wire
screws into the ball links attached to the control horn
on both sides.
•
Just like in the wing installation drill and tap the servo
screws and then wick thin CA into the holes to harden
wood, then re-install servo
•
Connect the rudder servo arm to the servo and the Pull
Pull ball link to the ends. Crimp the Pull Pull brass
collars and wick thin CA into them.
•
Pull the wire tight while ensuring the servo and
rudder are in there centered position thread and crimp
the brass collars along with wick thin CA into them.
Ensure that the wires are tight but not stressing the
servo and cross within the fuselage
