REDSTONE 3903701940, Translation Of Original Instruction Manual

Page: 38 / 68

LEROY MERLIN • Rue Chanzy - Lezennes 59712 Lille Cedex 9 - FRANCE
38 | GB
Old devices must not be disposed of with household waste!
This symbol indicates that this product must not be disposed of together with domestic waste in compliance with
the Directive (2012/19/EU) pertaining to waste electrical and electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can occur, for example, by handing it in at an authorised collecting
point for the recycling of waste electrical and electronic equipment. Improper handling of waste equipment may
have negative consequences for the environment and human health due to potentially hazardous substances that are
often contained in electrical and electronic equipment. By properly disposing of this product, you are also contributing to
the effective use of natural resources. You can obtain information on collection points for waste equipment from your
municipal administration, public waste disposal authority, an authorised body for the disposal of waste electrical and
electronic equipment or your waste disposal company.
18. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault Possible cause Remedy
Cutting wheel is loose after
the motor is switched off
Fixing nut not tight enough Tighten the fixing nut
Motor does not start
a) Mains fuse blown a) Check the mains fuse
b) Extension cable faulty b) Replace the extension cable
c) Connection to the motor or switch
not OK
c) Have this checked by an electrician
d) Motor or switch faulty d) Have this checked by an electrician
Incorrect motor rotation
direction
a) Capacitor defective a) Have this checked by an electrician
b) Incorrect connection b) Have an electrician transpose the wall plug
poles
Motor not supplying power,
fuse tripping
a) Cross section of the extension
cable insufficient
a) See “Electrical connection”
b) Overload due to blunt saw blade b) Replace the saw blade