23
•
Apply glue to the under side of the patch and around the area to be repaired. Too much glue will interfere with
a proper repair.
•
Allow adhesive to become tacky for 2-4 minutes, and then starting at one corner and working outward,
carefully apply the patch to the repair area using very firm pressure. Rub the entire patch area and the edges
of the patch using very firm pressure. Allow to cure for at least 12 hours before inflating and using.
13. GUIDE FOR THE PLACEMENT OF THE SCOOTER SURF ON THE WATER:
•
Once the board is inflated and the frame on the right position,
•
Make sure that the propeller is horizontal so as not to damage it. Helix does not need to be touched since it will
move by its own rotation.
•
Put the Scooter Surf on the water to a comfortable position to finish making the last adjustments.
•
Put the handlebar (rudder) on the straight position
•
Slide in the large Center Fin to the fin base and insert the push-in pin
•
Using the front handle and transport the SCOOTER SURF to the water depth of more than 0.5 m,
•
It is important that another strong person, always strongly holds the Scooter Surf so that you can get on without
having it unbalanced, until you are stabilized on the correct position on top of the Scooter surf.
•
While on the beach, the most comfortable way to get on the Scooter Surf will be from the back. Whether sitting
use the central area of the board specially designed for it, trying not to lean on the other areas. Important to
placing all our weight in the central part of the SCOOTER SURF to avoid capsizing.
•
If you want to climb on the Scooter surf while standing on a platform, you should ideally access from the SIDE,
placing one foot on the board center and quickly move to the middle of the board. In this case it is important to
bear in mind that the less time we are in between this action, the better because, depending on our weight, we
could make the Scooter Surf tip over.
IMPORTANT: Be sure to place and navigate with the Red Shark in areas deeper than 0.45 m
13.1.
GUIDE TO PICK UP THE SCOOTER SURF:
•
When you are at a depth of less than 0.6 m, stop pedaling and carefully descend from the water Scooter surf.
•
Whenever you maneuver the SCOOTER SURF out of the water, make sure that the propeller is horizontal so
as not to damage it.
•
The rudder blade must be in its closed position (using the bold ring clasp) to the place of use (dock, shore,
beach).
•
Remove the fin.
•
Using the front handle and transport the SCOOTER SURF to the edge of the beach.
•
Recommended: Using the front handle and the rear wheels (extra equipment), for transport the Scooter Surf
in to the land.
13.2.
GUIDE TO UNRAVEL THE SCOOTER SURF:
If for any reason, during navigation, the Scooter surf turns over, especially keep calm. Please move the overturned
the water Scooter surf instead of the depth being less than one meter. In no case will the Scooter Surf sink.
•
Place your body on the side of the overturned Scooter surf.
•
Hold the propulsion system with your hands.
•
Push the body backwards to turn the Scooter Surf to its correct position.
•
Climb carefully over the rear hull of the Scooter surf.
IMPORTANT: Above all, it is important that, when carrying out the turning movement of the Scooter Surf, be
careful that the rudder propeller, fin, frame... does not hit you.
