16
8. FASTENER TORQUE SPECIFICATIONS:
Correct tightening torque of threaded fasteners is especially important to your safety. Always tighten fasteners to the
correct torque. In case of a conflict between the instructions in this manual and information provided by a component
manufacturer, consult with your dealer or the
manufacturer’s
customer service representative for clarification. Bolts that
are too tight can stretch and deform. Bolts that are too loose can move and fatigue. Either mistake can lead to a sudden
failure of the bolt.
Excessive tightening will damage the element.
Always use a correctly calibrated torque wrench to tighten critical fasteners on your Scooter surf. Carefully follow the
torque wrench
manufacturer’s
instructions on the correct way to set and use the torque wrench for accurate results.
Although all fasteners on a water Scooter surf are important, pay special attention to applying the correct torque to the
following tightening Torques for RED SHARK SCOOTER SURF:
8.1.
STEM:
8.1.1.
Handlebar clamp bolt: 5 Newtons
8.1.2.
Carbon fiber handlebar clamp bolt: 3.9-4.9 Newtons
8.1.3.
Steerer clamp bolt 5 Newtons
8.2.
RUDDER:
8.2.1.
Bolts (3 Newtons)
8.3.
TRANSMISSION:
8.3.1.
Two bolts M6 (5 Newtons)
8.3.2.
One bolt M8 (6 Newtons)
9. DISASSEMBLY
In the present point, all the elements that make up the shipment of the SCOOTER SURF Red Shark will be broken down.
9.1. DISASSEMBLY OF PRINCIPLE ELEMENTS:
•
Board deflation
•
Separate the chassis (frame) with the propulsion from the board.
9.2. DISASSEMBLY OF SECONDARY ELEMENTS:
•
Rudder
•
Handlebar
