13
6.
Flip the Strider over and move arm into position so the notch at the end is aligned with the 5” or 6” hole in the
bottom of the center plate. Insert 4 Aluminum M3 x 8mm as shown
from the bottom of
the frame. Place
captive nut into the slot and screw tightly until captive nut is fully seated. Push arm inward against screw and
angle arm forward so it sits as far forward as possible in the kidney shaped slot. Tighten nylon locknut until arm
can only be moved with hard force. Repeat 4x until all 4 arms are assembled.
*Shown below in 5”
configuration. For 6” use the outer holes
