9
5. A dual position cable clamp is provided. For
top cable entry use retaining bar in horizontal
position supplied. For bottom cable entry
rotate retaining bar to the angled position.
6.
WARNING: THIS APPLIANCE MUST BE
EARTHED.
7. The earth
continuity
conductor of
the electrical
installation
MUST BE
effectively
connected
electrically to all exposed parts of the
appliances and services in the room in which
the water heater is to be installed in conformity
with the current BS. 7671 (I.E.E. wiring
regulations).
FINAL INSTALLATION PROCEDURE
AND COMMISSIONING
WARNING : DO NOT SWITCH ON THE
ELECTRICITY SUPPLY UNTIL THE
FOLLOWING PROCEDURE HAS BEEN
COMPLETED. FAILURE TO DO SO COULD
CAUSE THE PUMP TO RUN DRY AND
INVALIDATE THE GUARANTEE.
1. Fit the front cover back into position, ensuring
that both the control knobs are correctly
aligned with the flow valve and power selector.
Secure with top and bottom screws.
2. Fit hose and prime the shower first without the
handset to flush out any remaining debris. To
prime the shower ensure that the electricity
supply is switched off. Turn control knob
'B'
fully anti-clockwise. Water should start to flow
with motor switched off allowing all the air to
be purged out of the shower unit.
It may be necessary to lower the hose
below the level of the shower unit whilst
priming.
Stop water flow by turning knob
'B'
fully
clockwise. Attach handset, switch on electrical
supply and then operate the shower as on
page 2 and check–
a) That the water gets to a satisfactory
temperature
b) Water flow can be adjusted by knob
'B'
c) Power selection operates in both positions,
giving a change in water temperature
d) Check again for leaks
e) That the holes in the spray plate are not
blocked
f)
That the motor turns off and water stops
flowing in the
'STOP'
position
3. DEMONSTRATE OPERATION TO THE USER
Please leave these instructions with the user
for future reference.
ADDITIONAL ACCESSORIES
Cat. No.
White 2 metre shower hose
83-593529
1 metre riser rail
83-593530
Water control tap
93-792452
Shower de-scaling powder
95-711015
Curtain and rail pack
83-792802
Curtain and rail pack with non
slip bath mat
83-792801
Spare parts/accessories can be supplied
against any Visa or Access cards from
Redring Sales 01733 456700.
INLET ASSEMBLY SHOWING FILTER
POSITION
8mm
5mm
10mm
10mm
33mm
Live
Earth
Neutral
Diagram 10
Diagram 11
Summary of Contents for EXPRESSIONS 570
Page 11: ......
