Redmon ROCK ON, Owner'S Manual

Page: 4 / 16

OPERATION INSTRUCTIONS
The “Rock On” is simple, quick and safe to operate. Please read and
follow exactly all of the instructions that are included with this product.
BATTERY INSTALLATION: The “Rock On” operates on 4 “D” Cell
batteries (not included). Remove the battery compartment lid by carefully
turning counter clockwise the screw that holds the lid in place. Insert one
battery into each end of the battery compartment insuring that the batteries
are inserted with the proper polarity as shown in the diagram. Slide two of
the spacers out so that they contact the two batteries; then insert the two final
batteries with the last spacer in between as shown. The spacers are used to
insure the batteries are installed correctly. The unit will not function if the
batteries are installed with incorrect polarity.
Replace the battery compart-
ment lid by turning the screw clockwise; do not over tighten the screw. Do
not mix different types of batteries including new and old. Never try to
recharge batteries that are not made for recharging.
TESTING: Place your EMPTY infant car seat carrier on the base. The
carrier must sit level from side to side and fit between the two raised edges of
the “Rock On” base. If the bottom of the infant carrier is wider than the
“Rock On”; DO NOT USE; the two products are not compatible
. Next, pull
up the two safety straps and securely hook them to convenient locations
on the sides of the car seat and tighten them by pulling down on the straps
ends. Turn the switch “ON” and make sure that the fit of the Infant Car
Seat Carrier and the “Rock On” are working together as a unit for a safe
and secure combination of products. Turn the “Rock On” “OFF” and
remove the car seat by first lifting up on the finger tabs on the buckles to
loosen the straps.
LOADING: Secure the baby in the car seat first according to the car
seat manufacturer’s instructions. Remove pillows, bedding, bulky
hoods, and clothes from behind the infant’s head so that the baby can lie
back comfortably.
LOADING: The bottom of your infant car seat carrier has two curved
runners that are made for rocking and will fit the contour of the “Rock
On” platform. Place the car seat on the “Rock On” with these runners
centered front to back and side to side and so
4