AN-30 System User Manual
TDJ-
5818AM-60 18.0
Directional,
parabolic
PTP -5.4
25.3
No
limit
TDJ-
5816AM-90 16.0
Directional,
sector
PTP -5.4
25.3
No
limit
A
A
N
N
-
-
3
3
0
0
C
C
L
L
I
I
(
(
C
C
o
o
m
m
m
m
a
a
n
n
d
d
L
L
i
i
n
n
e
e
I
I
n
n
t
t
e
e
r
r
f
f
a
a
c
c
e
e
)
)
f
f
o
o
r
r
W
W
i
i
r
r
e
e
l
l
e
e
s
s
s
s
a
a
n
n
d
d
E
E
t
t
h
h
e
e
r
r
n
n
e
e
t
t
The CLI (Command Line Interface) System Configuration commands provide a simple to
use User Interface for the operator to input a complete set of system parameters for the
Ethernet, TDM card and Wireless components of the AN-30 terminal. The CLI command
format for Telnet and the RS-232 port is as follow:
<command> [parameter1] [parameter2] [parameter3]
8.1.
CLI General Commands
chgver (Change Software Version):
Swaps the operating and secondary software
versions
get (Get parameter value):
Get <parameter name> displays the value for a status
parameter. For configuration parameters, use Set command.
login:
Allows login under a different username and password
logout:
Disconnects user from the terminal.
passwd (Change Password):
passwd <username> <newpassword> Change password for
user.
reboot:
Reboot <time in seconds> Reboots the terminal.
resetstats (Reset Statistics):
Resets all statistics
save config (Save Configuration):
Permanently saves system configuration settings.
This command is required to activate all Configuration settings set previously
save snmp (Save SNMP Configuration):
Permanently saves SNMP configuration
settings. This command is required to activate all SNMP settings set previously.
set (Set parameter value):
Set one configuration parameter: <parameter name>
[<value>]. Without <value>, ‘set’ returns the actual value for configuration parameters.
For status parameters, use the Get command.
Page 30 of 80
Redline Communications
…..solving the first mile challenge