Redfox FE-30 EL, Instructions For Installation And Use Manual, Page: 6 / 28

6
6
CLEANING AND MAINTENANCE
ATTENTION! The device cannot be cleaned by direct or pressure water. Clean it daily. Daily maintenance
keeps longer useful life and effi ciency of the device. Before cleaning make sure to have disconnected the
device from electricity. Always switch off the main feeder to the device. Stainless parts wash with moist
cleaning cloth and non abrasive detergent than dry it by the cloth. Do not use abrasive and corrosive
detergents. All food residues must be removed from the surface, you can use scraper.
!!! YOU MUST LUBRICATE THE TOP WITH VEGETABLE OIL AFTER EACH CLEANING !!!
WHAT TO DO IN CASE OF BREAK-DOWN
Switch off the electric feeder and call seller´s professional service.
INDICATION
Guarantee does not cover all consumption parts succumable to common wear (rubber seals, bulbs, glass and
plastic parts etc.). The guarantee does not refer to the devices which were not installed in correspondence with
instructions - by qualifi ed worker, in conformity with standards and when somebody handled incompetently
the device (interventions into inner equipment) or the device was operated by non qualifi ed staff or at variance
with instructions for use. Guarantee does not also cover the damages caused due to infl uence of nature or
other outer intervention.
Point for cleaning steel-alloy plate:
• Heat up the device
• Turn of the device
• The plate pull off with scraper
• Apply water to chemistry (RM gril) and clean the plate from residual dirt and sediment
• Apply pure water (The solution is with vinegar or lemon)
• Pull off the water and than to dry the plate with rag
• Turn on the device up to 70 °C and from the plate let evaporate residual humidity
• To smear the grill areas with vegetable oil
Point for cleaning chrome plate:
• Heat up the device
• Turn of the device
• The plate pull off with plastic scraper
• Apply water with a saponate and clean the plate with a sponge
• Apply pure water
• Pull off the water and than to dry the plate with rag
• Turn on the device up to 70 °C and from the plate let evaporate residual humidity
NSTRUCTION FOR USE
Attention!Before the fi rst use of the device you must remove protection foil from all surfaces and wash the
device with water with detergent. Than splash it with clean water. Use the device under supervision. Never
use the device without oil or if the level of the oil is lower then min. line - danger of fi re. If the oil is dirty or you
use the oil longer time it may cause boiling over.
Do not fry more then 1 kg of food together in one bath. Fill the device with frying oil not higher than the line
on the side. Switch on with main switch (B) turn the knob (E) to required position between 90°C - 180°C.
Pilot lamps (C) and (D) will light. Pilot lamp (C) lights when the device is in elektricity and switched on. Pilot
lamp (D) lights when the thermo spirals are on. Pilot lamp (D) goes out when the device reaches required
temperature. Switch the device off by turning the knob (E) into position „0“ and switch over the switch (B) into
position „0“.
Comments and recommendation
You must always check the level of oil, never use the device without oil. Use the device only under supervision.
C
B
E D