17
7.0
ADJUSTING THE ANGLE OF THE JIGGING SIEVE
If material (rubber) does not pass the sieve and falls into the receptacle, you can prevent this
by adjusting the angle of the sieve. You can adjust the angle of the sieve by sliding the
handle at the side of the machine up or down.
Shown version: VT 1200 (The same principle applies to the VT 1800.)
Figure 14
The start procedure is as follows:
!! Make sure that the tractor / Verti-Top is blocked well and cannot move
on its own accord !!
!! Switch off the tractor before descending !!
1.
At both sides of the machine, unscrew the bolts
(Figure 14, A)
a few turns.
A set of keys is supplied with the machine; these are located in the
toolbox
(Figure 13, C)
.
2.
Adjust the angle of the sieve equally at both sides of the machine. For this
purpose, use the indication stickers
(Figure 14, B)
.
3.
Screw the bolts on both sides of the machine tight.
NEVER
adjust the machine in such a way that it could damage the subsoil.
!
IMPORTANT !
First check the working depth on the subsoil statically before using the machine!
