9
19
Safety decall 911.280.402; keep safe distance of 4 mtr (14’) to machine all the time for
bystanders and when maintenance is done or adjustments made, switch-off engine
20
Toolbox including manuals, combi tool and safety decall RA; read manual first.
21
Working depth adjustment spindle.
22
Fuel tank engine. See engine manual for instruction on kind of fuel and safety notes.
23
Seat rod activating safety switch. DON’T disconnect or short-cut switch. When nobody sits on
the seat, engine will die or not run.
24
Seat. Can be moved for optimum seat position.
25
Dynamic foot brake pedal.
26
Instruction decall for using certified ear protection when using the unit for more than 15 minutes.
Noise level of machine: 94 lBa.
27
Parking brake lever.
4.0 WORKING DEPTH ADJUSTMENT
The working depth can be adjusted when the machine is lifted from the ground as follows, see fig. 3.:
Unscrew nuts 1 at each side of the machine one turn. Screw spindle 3 in or out. Every revolution is 4
mm (0.160"). The decall 2 at each side of the machine shows the actual depth. When the correct
depth is reached, tighten the nuts 1 at each side.
@ Never adjust one side more than 4 turns. Compensate the other side first before proceeding.
@ The adjustment can be done with a special tool in the machine tool box.
@ The value at the decalls is only true when 150 mm (6") long tine are used. When shorter
tines are used, deduct the length difference to the 150 mm (6") from the actual decall reading
@ Clean and spray the spindle and nut with anti-sticking grease oil every 100 hours, o prevent dirt
sticking on the nut.
5.0 TINE ANGLE ADJUSTMENT
The adjustment of the angle of all tineholders is centrally located at the right side of the machine,
see fig.4..
290.50 (11.437")
Fig.3
Fig.4
3
4
5
6
1
2
