10
4.0 COUPLING / DISCONNECTING
Check procedure before starting the coupling of the Speed-Clean.
−
Check the Speed-Clean for visually observable damage and repair this if a safe
operation of the machine can no longer be guaranteed.
−
Check whether all nuts and bolts are tightened.
−
Check whether all protective covers and safety stickers are attached to the
machine and are not damaged.
Without them the machine must
NEVER
be used.
Fig. 7
The Speed-Clean can be coupled to the tractor by means of the 3-point linkage.
The method is as follows:
(Fig. 7)
1.
Remove the 3-point pins (1) and (2).
2.
Reverse the tractor carefully, so the lower connecting arms can be coupled to the
frame.
!! Make sure the tractor is blocked properly and cannot move of its own accord !!
!! Turn off the tractor before dismounting !!
3.
Connect the lower connecting arms with the 3-point pins connecting plate pins (1)
and secure these with the retaining pins supplied.
4.
Set the tractor’s stabiliser to 100 mm sideways stroke.
5.
Install the top link (3) on your tractor and unscrew this until it is at the same height as
the upper 3-point top connection of the Speed-Clean.
6.
Connect the top link (3) with pin (2) on the frame; secure pin (2) with the retaining pin.
7.
Screw in the top link (3) so that it is charged. Make sure the machine is parallel with
the ground.
!! Make sure that all the fastening pins are secured !!
8.
Start the tractor and lift the Speed-Clean from the surface.
Disconnecting takes place in reverse order.
