20
10. MAINTENANCE
Schedule
Check point
Method
Before
every
use
Check for loose bolts / nuts.
Tighten loose bolts / nuts with the
correct tightening moment.
Presence and readability of the safety
stickers
Replace these if not present or
damaged.
Check the knives.
Replace or repair them if damaged.
After
every
use
Clean the machine.
Clean the machine using air. If possible,
do not use water.
After the
first
20
working hours
(new or repaired)
Grease the bearings.
Use EP2 grease.
Check for loose bolts / nuts.
Tighten loose bolts / nuts with the
correct tightening moment.
Lubricate the chains.
Use a chain spray.
After
every
100
working hours
Check for loose bolts / nuts.
Tighten loose bolts / nuts with the
correct tightening moment.
Lubricate the chains.
Use a chain spray.
Check the chain tension.
If necessary, adjust it.
Check the sowing elements for dirt
and/or damage.
If necessary, clean or replace the
sowing elements.
Check the quantity of seeds.
Carry out the dispensing test.
Check the sowing pipes and/or funnels.
Clean these items if necessary.
Grease the bearings.
Use EP2 lubrication grease.
Check the grease level in the gearbox.
Top up to the correct level (see the
specification in Chapter 2).
Clean the seed tray.
Clean the seed tray using air. If possible,
do not use water.
Table 5
10.1
Lubrication points
To guarantee the proper functioning of the Overseeder 3D, the bearings at both sides of the rear roller
should be greased regularly (see Figure 8).
Grease these points according to the schedule shown in Table 5.
Figure 8
Summary of Contents for OVERSEEDER 3D 1275
Page 14: ...14 Figure 6 1 2 3 4...