19
STARTING TO SOW
The start procedure is VERY important. If this procedure is not executed as described below, it might
result in serious damage to the machine. The procedure is as follows:
1. Put seeds in the seed container.
2. Set the required dose of seeds by adjusting the gearbox (see Section 7.3).
3. Move to the location where you want to start.
4. Start at a speed of approx. 3 km/h (1.9 mph).
5. While driving, lower the machine gently and in a controlled manner, until the
sowing elements cut into the ground.
6. Increase the speed until the correct drive speed is achieved.
STOPPING TO SOW
1. Decrease the driving speed to approx. 3 km/h (1.9 mph).
2. While driving, lift the machine off the ground.
3. Go to the next location and start again as described above.
It is absolutely necessary to work according the aforementioned procedures. If the
machine is put into the ground in a non-operating position, serious damage to the
machine might occur.
While driving, lower the machine carefully and in a controlled manner during treatment.
NEVER drive in reverse when the machine stands on the ground.
Summary of Contents for OVERSEEDER 3D 1275
Page 14: ...14 Figure 6 1 2 3 4...