13
1. Loosen the stellar knobs
(1)
(see
Figure 5
).
2. Rotate the stellar knob
(2)
to change the settings. You can see the settings on the
sticker
(3)
.
3. Retighten the stellar knobs
(1)
.
Figure 5
7.4
Dispensing test
The quantity of seeds should be adjusted for the correct operation of the Overseeder 3D. See the
Tables 1, 2 and 3 for an indication of the required quantity.
You should consider the following instructions for this:
!!
Make sure that the Overseeder 3D is standing on its legs and is detached from the
tractor (see Section 6.2) !!
You will need the following accessories for adjusting the quantity of seeds:
1. A scale
2. A tray for weighing the seeds
3. Enough seeds for filling the hopper for minimum 30%
The procedure is as follows (see
Figure 6
):
1. Set the flap of the seed-element valves
(4)
to 0.
2. Fill the hopper with seeds and make sure that these are evenly spread throughout the
hopper.
3. Loosen the stellar knob (
1
) and slide the seed dispensing bin (
2
) out of the machine.
4. Rotate the seed dispensing bin 90° and slide it back into the machine.
5. Turn the wheel
(3)
13 rotations counter-clockwise.
6. Remove the seed dispensing bin (
2
) out of the machine and collect the seed in a tray.
7. Weigh the seeds in kilograms and multiply the outcome by:
Overseeder 3D 1275:
474
Overseeder 3D 1575/1575LV:
384
Overseeder 3D 2075:
291
The resulting outcome is the amount of seeds in kilograms that should be spread per hectare.
To obtain the outcome in pounds per acre, multiply the resulting outcome by 0.89.
!!
Attention !! If the bin is in a high position, it may cause the release of a large quantity
of seeds. Then divide the 13 rotations in several smaller steps!
3
1
2
Summary of Contents for OVERSEEDER 3D 1275
Page 14: ...14 Figure 6 1 2 3 4...