94
10.9.1
Remove factory bracket and replace with
notched bracket
(H)
on the outside wall
(H1)
of internal
knifebar with:
- exisitng hardware
For 10, 20 & 230 Series
For 240 Series Only
10.9.2
Remove factory bracket and replace with
notched bracket
(I)
or (
J
) on the outside wall
(H1)
of
internal knifebar with:
- exisitng hardware
10.9 Knifebar Engagement limiting bracket
Installation - Not required if combine is equipped with
hydraulic knifebar adjustment
Replace existing knifebar lockout bracket with new
bracket that is similar in shape
Parts List:
part included in CS970BS Kit
Internal Knife Lock-out Bracket:
CS838Z
Notched Bracket
240 Series Model Year <17,
230, 20, 10S KBar Adj 25%
(H)
Qty 1
CS837Z
Notched Bracket 240S <Model Year 17
KBar
Adj
25%
(I)
Qty 1
CS1064Z
Notched Bracket 240S >Model Year 17
KBar
Adj
25%
(P)
Qty 1
H
10.8.5
Attach CASE IH speed sensor
(F3)
to existing
mount plate
(D)
with:
Note: mount plate (
D
) is replaced with (
D2
) on 20S and
may have to be replaced with (
D2
) on pre 40S in order for
sensor to read off of alternate tooth pattern
Hardware included in CS622BS box - bag CS955S
- .5-20 hex jam nut
(F6)
- .563-32 hex jam nut
(F7)
- .563 flat washer
(F8)
Bottom of sensor must be within
1-2mm of rotating tooth - adjust
mount and add washer W11-09 (F8)
as required
H1
F3
F8
F6 F7
F
D
I
P
10.9.3
Remove factory sensor from existing bracket and
relocate to new bracket in similar position, with
- reuse existing hardware
D2
D2
CS833Z Speed Sensor Mount Plate
