RED DSMC MEDIA OPERATION GUIDE
COPYRIGHT © 2015 RED.COM, INC
955-0047, REV-R | 47
SET UP A STAND-ALONE RED STATION (WITHOUT RED STATION BASE)
This section explains how to connect a REDMAG 1.8" SSD to your computer using one of the following without
a RED STATION Base:
RED STATION REDMAG 1.8"
RED STATION REDMAG 1.8" (Mini)–eSATA
RED STATION REDMAG 1.8" (Mini)–USB 3.0
RED STATION REDMAG 2.5"
To offload media, follow the instructions below:
1. Place RED STATION on a firm, flat surface.
2. Connect the RED STATION to a computer using one of the following data connectors:
WARNING:
DO NOT connect more than one (1) data cable between one (1) RED STATION and the computer.
CONNECTOR
CABLE (INCLUDED WITH RED STATION)
NOTES
eSATA
RED STATION eSATA Cable (24")
After connecting via eSATA, it may take up to
15 seconds for the media to display on the
computer.
FireWire 800
RED STATION FW800 Cable (2")
RED STATION FW800 Cable (24")
The computer supplies power to the RED
STATION via the FireWire 800 connection, so
it’s not necessary to use the RED STATION AC
Power Adaptor. However, RED recommends
using the power adaptor for optimal
performance.
You can use the 2" FireWire 800 cables
(included with each RED STATION) to
daisy-chain the RED STATIONs. Then, use
one (1) FireWire 800 cable to connect one (1)
RED STATION to the computer. The computer
then recognizes each RED STATION through a
single FireWire connection.
MINI USB
USB-to-MINI USB Cable (24")
If connecting to the computer using a different
MINI USB cable than provided, power the RED
STATION with the RED STATION AC Power
Adaptor.
USB 3.0
(RED STATION
REDMAG 1.8"
(Mini) only )
RED STATION USB 3.0 Cable (24")
If connecting to the computer using a different
MINI USB cable than provided, power the RED
STATION with the RED STATION AC Power
Adaptor.
3. If using an eSATA connection, power the RED STATION with either of the following cables:
‒
RED STATION AC Power Adaptor
‒
RED STATION USB to DC Power Cable (24")
4. If offloading a REDMAG 1.8" SSD (48GB) or a REDMAG 1.8" SSD (512GB), power the RED STATION with
a RED STATION USB to DC Power Cable (24"). Using an eSATA or USB connection alone may not power
the RED STATION.
5. Set the
On/Off Switch
on the back of the RED STATION to
on
.
6. Install the REDMAG 1.8" SSD in the media slot on the front panel of the RED STATION.
The computer recognizes the inserted SSD media and displays the SSD as a new drive.
NOTE
: To offload data from the SSD, go to
