COPYRIGHT © 2015 RED.COM, INC
RED DSMC MEDIA OPERATION GUIDE
955-0047, REV-R | 46
CONNECT A REDMAG 1.8" SSD TO YOUR COMPUTER
This section explains how to connect a REDMAG 1.8" SSD to your computer using the following RED STATIONs:
RED STATION REDMAG 1.8"
RED STATION REDMAG 1.8" (Mini)–eSATA
RED STATION REDMAG 1.8" (Mini)–USB 3.0
RED STATION REDMAG 2.5"
NOTE:
You can daisy-chain most FireWire storage devices, including RED STATION RED MINI-MAGs and RED
STATIONs (for REDMAG 1.8" SSDs).
SET UP RED STATIONS WITH A RED STATION BASE
NOTE:
The RED STATION Base provides power to up to three (3) RED STATIONs (excluding the
RED STATION REDMAG 1.8" (Mini) and RED STATION RED MINI-MAG) using the RED STATION DC Power
Coupler (2") that’s included with the RED STATION Base.
1. Place the RED STATION Base on a firm, flat surface.
2. Place up to three (3) of the following RED STATIONs on top of the RED STATION Base, aligning the four (4)
bottom pegs with the four (4) rubber pads on top of the RED STATION Base:
‒
RED STATION REDMAG 1.8"
‒
RED STATION REDMAG 2.5"
3. Firmly press down on each RED STATION to insert the pegs into the rubber pads, creating one stacked unit.
4. Plug the RED STATION DC Power Coupler (2") into the
POWER
connector on the RED STATION Base and
one POWER connector of the RED STATION directly on top of the RED STATION Base.
5. Use RED STATION DC Power Couplers (2") to daisy-chain any remaining RED STATIONs by plugging the
cables into one POWER connector on each RED STATION.
6. Connect the RED STATION to a computer using one of the following data connectors:
WARNING:
DO NOT connect more than one (1) data cable between one (1) RED STATION and the computer.
CONNECTOR
CABLE (INCLUDED WITH RED STATION)
NOTES
eSATA
RED STATION eSATA Cable (24")
After connecting via eSATA, it may take up to 15
seconds for the media to display on the
computer.
FireWire 800
RED STATION FW800 Cable (2")
RED STATION FW800 Cable (24")
You can use the 2" FireWire 800 cables (included
with each RED STATION) to daisy-chain the RED
STATIONs. Then, use one (1) FireWire 800 cable
to connect one (1) RED STATION to the
computer. The computer then recognizes
each RED STATION through a single FireWire
connection.
MINI USB
USB-to-MINI USB Cable (24")
N/A
7. Set the
On/Of Switch
on the back of each RED STATION and the RED STATION Base to
on
.
NOTE:
When the On/Of Switch on the RED STATION is set to on, the On/Of Switch on the RED STATION Base
turns the RED STATION on/off.
8. Install the REDMAG 1.8" SSD in the media slot on the front panel of the RED STATION.
The computer recognizes the inserted SSD media and displays each SSD as a new drive.
NOTE
: To offload data from the SSD, go to
“Offload Data From Media to Your Computer” on page 48
.
