61
13 - MAINTENANCE AND CLEANING
Technical Dept. - All rights reserved - Reproduction is prohibited
DAILY OR WEEKLY CLEANING PERFORMED BY THE USER
Only a proper maintainance and cleaning of the product can assure you the correct functionality and a safe use of your stove.
ATTENTION!
All the cleaning operations of all parts must be performed with the product completely cold and the plug
disconnected.
Disconnect the product from the 230V power supply before performing any maintenance operation.
The product requires little maintenance if used with certified high quality pellets.
DAILY OR WEEKLY CLEANING PERFORMED BY THE USER
Brazier cleaning
Before ignition, always clean the brazier and remove any ash or incrustation from it that might obstruct the air flow holes, paying attention
to hot ash. In the case of ignition failure, or if fuel in the tank runs out, unburned pellets may accumulate in the brazier. Always empty the
residue in the brazier before each start-up. Only if ash is completely cold may a vacuum cleaner be used to remove it. In this case, use a
suitable vacuum cleaner to remove small sized particles.
REMEMBER THAT ONLY A CORRECTLY POSITIONED AND CLEAN BRAZIER CAN GUARANTEE SAFE IGNITION AND OPTIMAL
OPERATION OF YOUR PELLET PRODUCT. IN CASE OF FAILED IGNITION AND AFTER ANY OTHER LOCK STATE OF THE
PRODUCT, IT IS ESSENTIAL TO EMPTY THE BRAZIER BEFORE EVERY RESTART.
For the brazier to be cleaned properly, remove it from its housing completely and thoroughly clean all the holes and the grate on the
bottom. If good quality pellets are used, you will normally only need to use a brush to restore the optimal operating conditions of the
component.
Ash tray cleaning
Remove and empty the ash tray. Wipe away any residual ash before reinserting the tray. Your experience and the quality of the pellets will
determine the ash tray cleaning frequency. However, it is recommended not to exceed 2 or 3 days.
CLEANING THE ASH COLLECTION COMPARTMENT
