User’s Manual Code 001
Page 7-33
Rev 0819
7.4.2
Indoor controller and distribution wiring connection
The indoor unit can be wired by bringing the wires through the knock outs in the rear of the
mounting panel, this keeps all wiring internal and is the preferred installation option.
Alternatively, the wires can be brought in through the bottom of the mooting panel. If using
the bottom entry points, the grommet blacks should be removed carefully with a screw driver.
Ensure that 16mm cable glands are fitted and the cable is securely clamped.
When wiring to the board it is recommended the screw terminal plugs are removed from the
board to reduce the chance of damage to the control board. Ensure that all wiring is as per
instruction as failing to wire the board correctly will cause permanent damage to the board,
and under these circumstances the board will not be replaced under warranty.
Figure 21 Wiring inputs/outputs of indoor display unit
Summary of Contents for A10-UHE
