User’s Manual Code 001
Page 10-56
Rev 0819
The discharge pipe from the tundish should terminate in a safe place where there is no risk
to persons in the vicinity.
10.2.8
Low level indicator
The sight glass, brass nut and O-ring that go on top of the low level indicator are packaged in
the kit bag, to avoid damage during transportation. Remove the foam sticker from the low
level indicator body, add the O-ring seal, fit the sight glass and tighten the brass nut ensuring
that the sight glass markings can be read from the front of the tank and that the sight glass is
tight and cannot rotate.
10.2.9
Immersion heater
Install the bottom immersion heater as per Figure 28. The nut on the immersion heater is
46mm and a steel cranked spanner is supplied to fit this, do not excessively tighten, it is
recommended to wet the fibre gasket before fitting as this will continue to expand when
fitted and form a water tight seal. Ensure the earth wire is connected and then push on the
immersion thermostat ensuring that the spade connectors are fully engaged. Insert the M16
gland supplied in the kit bag and wire up the immersion fit the cover and fully tighten the
gland.
Figure 28 Immersion heater installation
Figure 29 Wiring cover plate
Summary of Contents for A10-UHE
