6
INSTALLING THE LP GAS CYLINDER (TANK) ONTO THE FIRE PIT:
1.
Check that the cylinder valve is closed by turning the knob clockwise. Inspect
cylinder valve rubber seal for cracks or deterioration. Do not use propane tank
with damaged seal as a gas leak may occur.
2. Place the cylinder at least 72-inches away from fi re pit to prevent it from
overheating.
WARNING:
DO NOT
route the hose under the fi re pit.
3. Locate hose where it will not be a trip hazard and the hose is not kinked or
damaged.
4. Install tank into tank holder and fully tighten the tank retaining screw to secure
the tank.
•
Inspect the propane tank valve rubber seal for cracks,
wear or deterioration prior to use. A damaged rubber
seal can cause a gas leak, possibly resulting in an
explosion, fi re or severe bodily harm.
•
Inspection should be done each time the propane tank is
connected to the fi re pit, has been refi lled, exchanged or
has not been used for more than 60 days.
•
Do not use a propane tank with a damaged rubber seal.
Exchange the tank or have the rubber seal replaced at a
qualifi ed propane fi lling station.
LP GAS CYLINDER (TANK) RUBBER SEAL INSPECTION:
Good
Rubber Seal
Damaged
Rubber Seal
HOSE / REGULATOR SPECIFICATIONS AND INSTALLATION:
The pressure regulator and hose assembly supplied with your fi re pit must be used.
•
DO NOT attempt to connect fi re pit, as purchased for LP (propane) gas, to any other fuel supply
source such as a natural gas line. For dual fuel fi re pits that can be converted to natural gas, a
Even Embers conversion kit must be purchased and installed for use with natural gas.
•
DO NOT use any other pressure regulator/hose assembly other than the one supplied with your fi re
pit. Replacement pressure regulator/hose assembly must be part No 2141-600-2141-0, which can be
obtained by contacting customer service at 1-855-735-9922.
•
DO NOT attempt to adjust or repair a regulator. The regulator is designed to operate at a
maximum output pressure of 11 inches of water column (2.74 kPa).
•
Ensure the tank valve is
CLOSED
prior to connecting the LP gas cylinder to your fi re pit.
Turn the valve knob clockwise to properly close the valve. Read and follow all instructions
and warnings on the supply hose safety tags. Read and follow all warnings in this manual
concerning the safe use of LP gas cylinders and the hose and regulator before connecting
cylinder to fi re pit. Read and follow all warnings on the LP cylinder.
WARNING
72” Minimum
Retaining Screw
