12
To obtain the best performance from your fi re pit, you must perform the following storage and maintenance
activities on a regular basis:
• Allow at least 35 minutes for the fi re pit to cool down after use, then disconnect and remove the cylinder.
• Cylinder must be stored outdoors in a well-ventilated area out of the reach of children. Disconnected
cylinders must have protective plastic cap installed and must not be stored in a building, garage or
any other close area.
• Storage indoor is permissible only if the cylinder is disconnected and removed.
• Keep the fi re pit area clear and free from combustible materials, gasoline and other fl ammable vapors and
liquids.
• If the fi re pit is not in use, it must be covered to protect from weather or other adverse elements.
• Installation and repair should be done by a qualifi ed service person. The fi re pit must be inspected at least
annually by a qualifi ed service person.
• It is imperative that the control compartment, burners and circulating air passageways of the fi re pit be kept
clean.
STORAGE AND MAINTENANCE:
TROUBLE SHOOTING:
Problem
Possible Cause
Prevention/Cure
Gas Odor
Gas Leak
Leak check all connections
Burner won’t light while
using a match
Low gas pressure
Check gas supply pressure
Regulator isn’t connected securely
Tighten regulator connection to propane tank
Clogged or dirty burner ports
Clean burner ports-see manual section
Gas fl ow is obstructed
Check hose for kinks and bends
Incorrect burner fl ame
Burner ports are clogged or blocked
Clean burner ports
Clogged or dirty burner ports
Clean burner ports-see manual section
Fire Pit won’t light
Ignitor pin and burner are wet
Dry off with soft cloth
Ignitor pin is broken
Contact Even Embers for a replacement part
Electrode wire is loose or disconnected
Reconnect wire to the ignitor
Electrode wire is shorting
Contact Even Embers for a replacement part
Fire Pit emits a lot of
black smoke
Flame is obstructed at burner
Check burner ports are free of any debris
Regulator hose is kinked
Straighten hose of all bends and kinks
Sudden drop in gas fl ow
No gas fl ow
Check that the propane cylinder is not empty
Regulator fl ow limiting device has been activated
Follow “Resetting Regulator Procedure” section in this manual
Flame blows out easily
High or gusting winds
Increase fl ame to “HIGH”
No gas fl ow
Check that the propane cylinder is not empty
Regulator fl ow limiting device has been activated
Follow “Resetting Regulator Procedure” section in this manual
