![background image](http://html1.mh-extra.com/html/red-rooster/tcs-500-at2s/tcs-500-at2s_user-manual_1428179015.webp)
15
USER MANUAL
▪
Red Rooster Lifting Limited
▪
Nauta House, The Meadows, Oldmeldrum, Aberdeenshire, AB51 0EZ
▪
Tel: +44 (0) 1651 872101
▪
M01-AH12-AT REV1
GETTING STARTED - INSTALLING THE HOIST & TROLLEY
1.9
FITTING TROLLEYS IN LOCATION
MOUNTING FROM THE RAIL END
Air trolleys can either be fitted to the runway beam or swing jib in two ways.
1)
By removing the end stop from the beam and sliding the trolley which is already set for the flange size on to the beam and then re-fitting
the end stop.
MOUNTING BY DISASSEMBLING THE MAIN TROLLEY BODY
2)
By opening the trolley up so that the inner part of the wheels will pass over the beam flange and then sliding the trolley side plates back
along the shaft, refitting the spacers, washers and nuts and then tighten up the nuts and check the wheel setting. Be sure to firmly
support the parts during reassembly from the bottom side so that the side-plates are not twisted or otherwise shifted. On completion of
reassembly, be sure to confirm that various shafts, nuts, lock pins and split pins are properly fastened without any slack and have not
been loosened.
END STOP
PLAIN SIDE PLATE
ASSEMBLY
MOTOR SIDE PLATE
ASSEMBLY
Summary of Contents for TCS-500-AT2S
Page 1: ...AIR HOIST TROLLEY USER MANUAL MODEL TCS 500 AT2S ...
Page 2: ......
Page 60: ......
Page 66: ......