Light up in red for one second.
A long beep for one second.
The screw is refastened after fastening (NOK).
The screwing fastener must be performed again.
Light up in green.
The preset torque is reached and the tightening is
OK.
-
Blinks in yellow for five times.
Five short beeps
The battery power becomes low
Replace the battery with a fully charged one
Light up in yellow for five seconds.
A long beep for five seconds
The battery power is used up, the tool stops
immediately.
Replace the battery with a fully charged one.
Light up in blue.
The tool is in reverse operation
-
Blinks in red for two times
The motor is too hot
Remove the battery and let the tool cool down, and
then reattach the battery. The tool can work properly
again.
Blinks in red for three times.
The motor has failed.
Send to the service center.
Blinks in red for four times
The connector wire has failed.
Send to the service center.
Left – Right rotation:
For left rotation: push the F/R button, blue light > tool is in left rotation. Push F/R button again for right rotation.
Automatically switching back from left to right rotation: push the F/R button for 5 seconds until the blue LED blinks once, now the tool rotates one cycle in left direction and after stopping the tool
switches automatic to the right rotation. Deactivating: holding the F/R button again for 5 seconds until the blue LED blinks once.
RPM setting pistol model:
With the "Programmer" the rpm of the motor can be adjusted, see manual of the Programmer.
Maintenance:
Check the tool regularly for loose bolts/screws or parts.
In case of power loss: Have the tool repaired.
Only trained and qualified engineers are allowed to adjust or repair the tool.
In case of disposal of the tool, follow local regulations, so as much as possible can be recycled. Do not throw it in the normal waste bin.
The tool should be maintained regularly to minimize the noise emission and occurring vibration.
Intended use:
The user or the user's employer shall assess the specific use that can be present as a result of each use.
Never use the tool otherwise than the tool is designed for and as explained in this manual.
Damages as a consequence of not following this manual, or caused by incorrect use or incorrect repairs, will never be covered by our warranty and we will have no responsibility for it. We reserve
the right for technical improvements, without prior notification.
This tool is designed for tightening processes on threaded fasteners, if used otherwise a risk assessment has to be made by the employer/user.
