-28-
PANEL INSTALLATION
The unit meets NEMA 4/IP65 requirements for indoor use, when
properly installed. The units are intended to be mounted into an
enclosed panel with a gasket to provide a water-tight seal.
Two
mounting clips and screws are provided for easy installation.
Consideration should be given to the thickness of the panel. A panel
which is too thin may distort and not provide a water-tight seal.
(Recommended minimum panel thickness is 1/8"
{3.2mm}
.)
After the panel cut-out has been completed and deburred, carefully
slide the gasket over the rear of the unit to the back of the bezel. Insert
the unit into the panel. As depicted in the drawing, install the screws
into the narrow end of the mounting clips. Thread the screws into the
clips until the pointed end just protrudes through the other side. Install
each of the mounting clips by
inserting the wide lip of the clips into
the wide end of the hole, located on
either side of the case. Then snap the
clip onto the case.
Tighten the
screws evenly to apply uniform
compression, thus providing a
water-tight seal.
CAUTION: Only
minimum pressure is required to seal
panel. Do NOT overtighten screws.
APPENDIX “A” - INSTALLATION & CONNECTIONS
INSTALLATION ENVIRONMENT
Before Installing the IM into the panel, the user should first become familiar
with the unit. It may also be desirable to program the unit for the application.
When programming is complete, all parameters will be saved in nonvolatile
memory. The Program Disable (PGM.DIS.) terminal should be connected to
COMM. to prevent accidental or unauthorized programming changes. The unit
should be installed in a location that provides good air circulation. Be sure to keep
it away from heat sources (ovens, furnaces, etc.), away from direct contact with
caustic vapors, oils, steam, condensation, or any other process by-products in
which exposure may affect proper operation.
The bezel should be cleaned only with a soft cloth and neutral soap product.
Do NOT use solvents. Continuous exposure to direct sunlight may accelerate the
aging process of the bezel.
Do not use tools of any kind (screwdrivers, pens, pencils, etc.) to operate the
keypad of the unit.