Classe BS2 v1.0
6
After 2300 hours the fixture will no longer respond to DMX commands and
immediately enter a hibernation mode that will electronically discontinue all fixture
functionality with the exception of a few menu commands. The fixture will continue to
enter hibernation mode until the lamp is replaced and the lamp clock has been reset.
Before replacing the lamp let the lamp cool down, because during operation, the lamp can
reach very high temperature.
During the installation of halogen lamps do not touch the glass bulbs bare handed. Always use a
cloth to handle the lamps during insertion and removal.
Do not install lamps with a higher wattage. They generate higher temperatures than which the
device was designed for.
For the installation, you need one: PLATINUM 5R
Procedures:
1)
Unscrew the 2 screws (A, B) on the bottom of the housing, holding the plate where the lamp is
underneath. Carefully remove the metal plate.
2)
Insert the lamp counter-clockwise 35 degree into the lampholder, then turn clockwise 35 degree
to put it into the right position. Attention: please wrap the lamp with the soft cloth that comes
with the packing, avoid naked hand contact to the lamp directly.
3)
Put the lampholder back position after install the lamp, tighten the screw and complete the
installation.
Please remember the lamp is not a hot-restrike type, you must wait for approximately 10
minutes after having turned off the lamp before you can turn it back on again.
Please remember the lamp is not a hot-restrike type, you must wait for approximately 10
minutes after having turned off the lamp before you can turn it back on again.
Do not operate this device with open cover
4.2) Mounting the device
The applicable temperature for the lighting is between -10°C to 45°C. Do not use the lighting under
or above the temperature.
Summary of Contents for Classe BS 2
Page 1: ......
