5. Loosen and remove the four (4) M4x0.7 x 8 mm lens mount screws in a cross pattern (“X” pattern) using a T20
TORX driver.
NOTE:
The DSMC Mg PL Mount 2.0 has captive screws that are not removable from the mount.
NOTE:
Screw removal may require a large handle T20 TORX driver and additional leverage.
Figure: Remove the Lens Mount Screws
6. Remove the lens mount from the camera.
Figure: Remove the Lens Mount
INSTALL A LENS MOUNT
NOTE:
You can change lens mounts in the field. However, RED recommends that you change lens mounts only in a
dust-free environment.
REQUIRED TOOLS:
T20 TORX driver
1. Ensure that the camera is turned off and remove any accessories or cables that may interfere with installation.
2. Inspect the gold electrical contact pins on the front of the camera and the gold contact pads on the rear of the lens
mount to ensure that they are free of any contamination.
C O PYR I G HT © 2 0 1 6 R ED.C O M , I NC
9 5 5 - 0 1 3 3 _V 6 .3 , R EV - H
|
2 3 3
SCARLET-W OPERATION GUIDE