Recsea WHC-S120, Manual

Page: 5 / 12

ATTENTION!
※
The housing Mode Dial and rear Control Dial are designed to turn the camera's mode dial
and control dial back and forth via friction from O-rings that comes in contact with these
controls inside the housing. When installing or removing camera pull Mode Dial up.
※
The housing Strobe Up Switch Dial is designed to manipulate the camera strobe switch via
a small lever inside the housing. To preset the lever pull the Strobe Up Switch Dial out
away from housing body and turn dial until the lever is pointing to the rear of the housing.
※
IMPORTANT! After installing place the Mode Dial in the proper position down and in
contact with the the camera mode dial and Push Strobe Up Switch Dial so it is in the
proper position for immediate use.
※
Should the internal control wheels of either the housing Mode Dial or Control Dial begin to
slip, use a soft dry cloth to wipe away any oil and other contaminates that may cause the
loss of friction from the O-rings and camera dials.
※
Refer to camera manual for explanation of camera functions.
※
Use Strobe Mask-External Strobe Connection Mount as required for attaching fiber optic
flash cables.
※
Attach Diffuser using the grooved provided on the Lens Port.
OPENING AND CLOSING THE BACK COVER
※
Please do the following operations in a clean area with low humidity and dust.
To OPEN, press Lock Lever while pulling Secure-Latch away from housing main body.
3.