Recognition Systems HandPunch 1000, Manual

Page: 15 / 70

HandPunch 1000 Manual
Page 13
Mechanical Installation
Select an installation location based on the guidelines provided in the Planning
an Installation section beginning on page 9.
Wall Plate Installation
Wall Preparation
For the following procedure protect the HandPunch from the dust and debris
generated during the wall plate installation process.
1. Remove the wall plate from the packing carton. Refer to Figure 3-1 for all
wall plate references in the following section.
Figure 3-1: Wall Plate
2. Measure and mark a point 48 1/2 inches (123 cm) from the surface of the
finished floor. This point will correspond to the Leveling Hole where the top-
center point of the HandPunch should be mounted.
3. For a hollow wall, drive a small nail into the wall at the mark and hang the
wall plate from the Leveling Hole located near the top of the wall plate.
4. For a solid wall, hold the wall plate against the wall, centering the Leveling
Hole over the mark in the wall.
WARNING
2 UPPER SCREWS
HOLE
SURFACE
CONDUIT
ENTRY