Rebel MAJOR 4i BLACK, Assembly And Operating Instructions Manual

Page: 67 / 76

65
4. Open gas supply from the low-pressure
regulator slowly, to stabilise the gas pressure.
43.3 Gas cylinder removal
1. Use the low-pressure regulator to turn off
the gas flow.
2. Check that all controllers of the barbecue
are in the OFF position.
3. Detach the low-pressure regulator from the
gas cylinder.
Do not replace the gas cylinder near open
flame or embers.
43.4 Prior to first use
Before first use of the barbecue, carry out full
leak testing in accordance with the
instructions. Light the barbecue and use all
burners at MAX power for approx. 5 minutes
(but not longer) with the lid open. After that,
close the lid and continue using the barbecue
at MAX power for additional 2-3 minutes.
Once this is accomplished, the storage grease
residues have burned off. Let the barbecue
cool for about 15 minutes. Clean the grid and
grilling plate by BBQ cleaning brush. Oil the
grid and grilling plate with some cooking oil.
Now the barbecue is ready for use.
43.5 Leak test
Leak testing is always required in the
following cases:
• Before first-time ignition of the barbecue.
• Every time a new gas cylinder is installed
or some component replaced.
• We recommend performing the test at least
once a year, before every barbecue season.
Always carry out the leak test outdoors, away
from heat, open flame, and combustible
liquids. Do not smoke while performing the
test. Always use 50/50 liquid soap/water
solution for leak testing. Never use a match or
open flame.
43.6 Always check the following when
carrying out a leak test
• Gas cylinder valves and cylinder thread.
• All gas cylinder welds.
• Regulator mounting and gas cylinder
connections.
• All hose joints (including side burner
hoses, if present).
43.7 Carry out leak testing as follows
• Use a recently filled and checked gas
cylinder connected to the barbecue with all
of the barbecue connectors in the OFF
position.
• Open the pressure regulator.
• Using a brush and soap/water solution, wet
all of the connections and components
specified in step 43.6.
• Check carefully for bubbles (signs of gas
leakage).
• If bubbles appear next to connections,
tighten the connections until retesting
shows no sign of leakage (always turn off
gas supply for the duration of leakage
repairs).
• Close the pressure regulator and make sure
the control valves are closed.
Do not use the barbecue if you fail to
eliminate a leak. Close the gas cylinder valve,
detach the gas cylinder and contact the
importer.
44. USING THE BARBECUE
44.1 Ignition by battery operated piezo-
igniter
1. Always open the barbecue lid before
igniting a burner.
2. Turn on gas supply from the cylinder and
low-pressure regulator.
3. Press control knob to bottom and turn it
anticlockwise till position.
4. Push ignition button until burner ignites.
5. Adjust the burner flame by turning the
controller between high and low power.
65
www.rebel.fi