Rebel TOOLS RB-1002, User Manual

Page: 37 / 147

37 EN
Battery level
To check the battery level press the button at the back of the battery.
• When the battery is fully charged, all three LEDs are on.
• When the battery is half empty, two LEDs are on.
• When the battery is empty, only one LED is on. Charge the battery immediately.
Charging
• Place the AC charger on a flat and stable surface within about 1 meter from the power
supply socket.
• Remove the battery from the power tool. Press and hold the battery release button (9)
and at the same time slide out the battery.
• Slide the battery to the AC charger maximally so that it locks in place.
• Connect the AC charger to the power supply socket.
• When the battery is fully charged, slide it out from the AC charger and slide it in the
power tool so that it locks in place.
Charging indicators
The AC charger has charging indicators which indicate the status of the charging process:
LED Status
Red Battery charging in progress
Green Battery charging finished, battery fully charged
• It takes about 1,5 hour to fully charge the battery.
• AC charger and battery may heat up during charging. It is a normal behavior.
• When power tool is not in use, it is recommended to charge the battery every three
months.
• When you notice that the power tool performance is decreasing, recharge the battery.
Fitting and removing drill bits/screwdriver bits
To fit/remove a drill bit/screwdriver bit:
• Set the rotation direction switch (7) to the middle position.
• Rotate the sleeve right to open the chuck jaws. Place the drill bit/screwdriver bit as far
as it will go in the chuck (1), then rotate the sleeve left to tighten the chuck.
• Rotate the sleeve right to open the chuck jaws what allows to remove drill bit/screwdriver
bit safely.