Rebel TOOLS RB-1001, User Manual

Page: 43 / 179

43
EN
7. Only use the charger at ambient temperatures b10°C and
+40°C. Store charger in a dry location protected from cold where
temperature would not 40°C.
8. The charger is intended for indoor use only. Place charger on
solid, flat non-flammable surface and away from any flammable
materials when re-charging the battery pack.
9. Do not recharge the battery pack in a wet or humid environment.
The charger and battery pack may heat during charging process.
Additional safety warnings for screwdrivers
• Hold the power tool with a firm grip with both hands (if possible)
and keep a good balance. The tool is best guided with both hands.
If bit gets locked, a strong torque reaction may occur when screwing
in or loosening screws.
• Use appropriate detectors to determine if utility lines are hidden
in the work area or call the local utility company for assistance.
Contact with electric lines can lead to fire and electric shock.
Damaging a gas line can lead to explosion. Penetrating a water line
causes property damage or electric shock.
• Secure the workpiece. Never hold the workpiece in your hand or
across your legs or against your body. A workpiece clamped with
clamping devices or in a vice is held more secure than by hand. An
unstable workpiece can cause loss of control of the tool and/or injury.
• Do not use dull or damaged bits and/or accessories. Dull or
damaged bits/accessories have a greater tendency to get jammed in
the workpiece, or to break, or to be ejected.
• When installing a bit/accessory in the chuck, insert the shank of
the bit/accessory well inside the chuck.
If the bit / accessory is not
inserted deeply enough, the grip of the chuck over the shank of the
bit / accessory is greatly reduced likely to increase the risk of loss
of control. After inserting the bit, pull on it, so as to ensure that it is
properly locked.
• If the bit becomes bound or jammed in the workpiece, immediately
stop the tool by releasing the trigger switch, then reverse the
rotation direction and slowly squeeze on the trigger switch to
release and remove the bit. Be ready for strong reaction torque
likely to cause a kickback.