6
ForceFeel
1.4 Intended Use and Reasonably Foreseeable Misuse
The ForceFeel pad is intended to be used as device for the vibration feedback from games.
The pad is intended for indoor use only. The pad should shall only be used according with the
instruction as described in this manual. All use other than described in this manual is seen
as unintended use.
The ForceFeel shall be used with the following software only:
ForceFeel Control Center
SimShaker™
2. DESCRIPTION OF THE PRODUCT
2.1 Technical Data
Parameter
Unit
Device name
Realteus ForceFeel
Designation
Haptic Gaming Pad
Type
FF08
Technical life span
5-10 years
Voltage/Frequency
100 - 240V DC12V / 50-60Hz
Materials
Artificial leather (PU)
Dimensions (Extended)
1070 mm × 477/461 mm × 15 mm
42.12 inches × 18.77/18.14 inches × 0.59 inches
Weight
1.8 kg ( 4 lbs )
Maximum load
150 kg ( 330 lbs )
2.2 Product Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Caution to the user that changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
NOTE
: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
