Instructions for the Special Edition #SE-JM907 The Alison, Jr.
E: Roof
Page 15
Housebody Roof:
Preview:
In this section you will draw Shingle guidelines,
and attach the Roof Panels and Roof Tops.
25. Glue and tape the Ledge Trim to the exposed edges
of the Top Floor, fl ush along the bottom edge (the Ledge
Trim sticks up above the Floor).
26. On the outside of the Front and Side Roof Panels
draw guidelines for locating Shingles. The fi rst guideline
should be drawn one Shingle length (
1
1
/
4
) from the bottom
edge. Draw the rest of the guidelines spaced 1” apart (Il-
lustration #21 and the Guideline Measure at right).
27. Without glue, Test the Roof panels on the house
to see how they fi t. Take the Roofs off, then glue and tape
them to each other, to the Top Floor, and to the Tower Top
Sides (Illustration #22).
Check to make sure the Roofs are fl ush with the edges
of the Tower Top Sides on the inside.
28. Set the Attic Divider inside the attic against the
Front Roof. Make absolutely sure that the Front Roof is
fl ush with the top edge of the Attic Divider and the Tower
Top Sides (Illustration #22). Let the glue dry.
Illustration #21
Shingle Guidelines
One
One
Shingle
Shingle
Length
Length
1”
1”
1”
1”
1”
1”
1”
Illustration #22
Right
Front Roof
Left Front
Roof
Attic Divider
Attic Divider
Side Roof
Side Roof
Side Roof
Side Roof
Ledge Trim - lined up on the bottom
Step 25
Step 25
Pro Tip: it is far easier to pre-cut wallpaper to fi t the roofs before attaching the roofs to the house.
Wiring? Visit www.realgoodtoys.helo/JM907/wiring for steps to do right now.
