Real Fires Electronic Range User Guide & Service Manual
8
Service Instructions
Disconnect the mains power before commencing any service work.
Servicing is only to be carried out by a certified gas fitter.
Refer to the Parts Diagrams on page 11 for more details.
It is not necessary to remove the outer trim but it is recommended to do so
with the non-glass trims as they can be scratched during service if not careful.
Remove the outer trim (metal trim only) by carefully pulling the bottom of the
trim leg outwards until the spring-loaded trim retainer is at its limit. Push the
retainer down and the leg should become free. Once both sides are free, lift
the trim up off the top trim hangers.
Remove the side reflectors: (Note:
there is a tab at the top centre of each
reflector holding it in place, this will need to be lifted up to release the reflector.)
•
Minimal and Pearl fires
– This is done by pulling the top of the reflector
out slightly and rotating the top of the trim towards the centre of the
firebox and lifting it away from the burner.
•
Modern and Classic fires (grated front)
– This is done by pulling the
reflectors straight out of the fire. Take care not to scratch the outer trim if
it is still attached.
Remove the front panel:
• Remove the earthing screws on the top left and right of the front trim
and carefully lift the trim straight up until free of the locating screws. If
the outer trim has not been removed it may be necessary to lift the front
panel up until it can be rotated into the firebox for removal.
Remove the main burner:
• Remove the two screws holding the burner assembly in place. Slide the
burner and tray out and lift upwards.
• If servicing the pilot only, the burner media can be left as it is on the
burner, otherwise:
- Carefully remove the burner media and inspect the burner for signs
of wear or damage.
- Vacuum the top burner ports and inspect the Primary Aeration
ports and Aeration Sleeves (if fitted) on the underside of the burner;
vacuum if required.
