re3D GIGABOT 3+, Quick Start Manual, Page: 20 / 32

IMAGE BOX:
Option A.
1. Place Image
2. Sent to Back
IMAGE BOX:
Option A.
1. Place Image
2. Sent to Back
IMAGE BOX:
Option A.
1. Place Image
2. Sent to Back
20
Install the [10864] spool holders to the back
of
Gigabot
®
with 2x M5 magic t-nuts, 2x M5
flat washers, and 2x SHCS M5x16 each using a
4mm Allen key to fasten the hardware. For
Gigabot
®
Regular, the spool holders should be
on the far left and far right vertical rails. For a
Gigabot
®
XLT, the spool holders mount to the
far left and middle right vertical rails.
C1
Place the filament spool onto the spool holder.
The filament should feed from below the spool
and into the Filament Detection (FD) unit
nearest to it.
C2
Prior to inserting the filament into the guide
tubes, use the dust cleaning cloth to clean it.
Insert each filament into its tube, wrap a
filament cleaning cloth around it just below
the FD unit, and then secure it using the
spiralite.
C3