ICENI/AI-04
6
UNPACKING & INITIAL PREPARATION FOR USE
6.1
Unpacking
The module should be removed from the sealed bag inside the protective cardboard
carton. All packaging should be disposed of in an appropriate way.
6.2
Node Assembly
The module is designed to clip and fit onto TS 35 DIN terminal rail (both standard
and deep types) with other Iceni modules to form a node. A metal clip is provided on
the base of each module for this purpose.
DIN rail clip
An Iceni node can be mounted in both vertical and horizontal orientations according
to terminal rail layout. Assembly of the Iceni node can be achieved in one of two
ways:
o
The Iceni node (including the ICENI/AI-04 module) can be assembled on a
bench and then fitted into place on the DIN rail with a slight tilting action. It is
important that the metal DIN rail latch on the underside of each module engages
properly with the rail to retain the modules in place.
o
The ICENI/AI-04 module can be fitted with other modules one at a time on the
DIN rail with a slight tilting action. It is important that the metal DIN rail latch on
the underside of each module engages properly with the rail to retain the module
in place. The modules can then be pressed together tightly to ensure that each
module plugs into its neighbour to form the node.
6.3
Node Disassembly
Disassembly of the Iceni node is essentially the reverse of the procedure above and
can be achieved in one of two ways:
o
Each module can be separated from the next on the rail. The metal DIN rail latch
can then be operated with a small screwdriver and the modules removed with a
tilting action, one by one.
o
The metal DIN rail latches for all modules can be released in turn with a small
screwdriver until the Iceni node is free to be removed with a tilting action. The
modules can then be separated from each other.
Pub_3645
Page 14 of 25
